AeroBed Valve Replacement Instructions

Valid for All AeroBed Products

Tip: If you are experiencing difficulty replacing your valve because the soft black valve is too stiff, you can warm the flange with a standard household hair dryer. The vinyl will warm and soften after a few minutes. Do not use a heat gun as this may damage your products.

Valve Closed Position Place your thumb on the tab and your index finger underneath the valve lid. Squeez tab away from hinge to release (Figure 1). Once the tab clicks open, easily lift tab cover to open position.

The valve will open as shown (Figure 2).

Removal of Valve To remove the old valve, at tab latch peel soft black rim back and lift the hard black plastic on the outer edge of the valve toward the center (Figure 3). The valve will then be easy to lift away. You are now ready to install the replacement valve.

Replacement of Valve To install the new new valve, first open the replacement valve top (Figure 1). Once open, seat the hinge area onto the hinge support. Squeeze the soft vinyl ring toward the center of the mattress opening. Feed the vinyl through the opening of the new valve. Do not use any tool or sharp objectas this may damage the flange or puncture the mattress. After the vinyl has been fed through the opening, make sure there are no bulges in the vinyl ring. Slide your thumb around the inner edge to make sure that it is smooth. Next, lock your replacement valve in closed position. Your are now ready to inflate your AeroBed.

View Replacement Valves

	Place your thumb on the tab and your index finger underneath the valve lid. Squeez tab away from hinge to release (Figure 1). Once the tab clicks open, easily lift tab cover to open position.
	The valve will open as shown (Figure 2).
	To remove the old valve, at tab latch peel soft black rim back and lift the hard black plastic on the outer edge of the valve toward the center (Figure 3). The valve will then be easy to lift away. You are now ready to install the replacement valve.
	To install the new new valve, first open the replacement valve top (Figure 1). Once open, seat the hinge area onto the hinge support. Squeeze the soft vinyl ring toward the center of the mattress opening. Feed the vinyl through the opening of the new valve. Do not use any tool or sharp objectas this may damage the flange or puncture the mattress. After the vinyl has been fed through the opening, make sure there are no bulges in the vinyl ring. Slide your thumb around the inner edge to make sure that it is smooth. Next, lock your replacement valve in closed position. Your are now ready to inflate your AeroBed.

Email